Therapy Lounge Accessories

Car Rear

Here are some more information for Car Rear:

Principles of Race Car Design

The principle of race car design is similar to the one that flies the airplane. The only difference is that in case of airplane wing or airfoil is shaped upward whereas in case of race car the wings are mounted upside down. The difference in the direction of the wings is because the airplane needs a lift and a race car needs a downforce. In any case, both work on the principle of aerodynamics, a refined form of science that studies the affect of air on a moving object.

Earlier aerodynamics was only restricted to race cars like those in F1 cars but these days’ high-end luxury cars like BMW and Audi are also adorned with aerodynamic design specifications in order to improve performance and mileage.

The two basic principles of car aerodynamics are drag and downforce. These define the speed, control, and even mileage of any car.

Drag

Some energy is required by cars to move through the air. This energy is used in overcoming a force known as drag.

When there is air resistance, the measurement of drag helps to define complex dependencies of shape and inclination. This measurement is known as drag coefficient which is calculated experimentally through

Cw = W/A v2* Q/2

Where, Cw is drag coefficient, W is air resistance, A is cross-sectional area, V is driving speed, and Q is air density.

In car aerodynamics, drag actually comprises of two forces, frontal pressure and rear vacuum. Frontal pressure is generated by the air that attempts to flow around the front of the car. As air moves towards the front grille or bumper, the air molecules begin to compress and increase the air pressure at the front of the car. This puts extra pressure on the engine to run the car, so if the front is sleek, the air pressure distributes along the sides of the car, thereby increasing the speed of the car.

Rear vacuum pressure applies to the hole that a car leaves behind in the air while moving. The boxy structure of the car creates a bigger vacuum behind the car and the air molecules are not able to fill in the empty space. This creates an opposite force which increases the force required to overcome the air resistance. The inability of air molecules to fill the space is known as flow detachment which creates turbulence. Therefore, the entire length of the car needs to be modified to support the aerodynamic structure of the car.

Downforce

Downforce is the pressure caused by moving air that flows over the surface of the car and creates weight on the area. Downforce helps increase tyre grip and cornering speed. This can be simply done by introducing inverted wings to force the car down on the track.

Air pressure is high when it approaches the front of the car and then gradually air slows down, resulting in more molecules packed into a smaller space. When the molecules stagnate, it hunts for a lower pressure area that includes the sides, top and bottom of the car. Further to that air loses the pressure as it travels through the car’s hood but when it hits the windscreen it again increases. The air pressure created above the hood of the car creates a downforce that puts the car stable on racing tracks even at high speeds. Therefore, there should be less surface area on the roof of the car.

Conclusion

To have better car dynamics ideally the racing car should have sleek body structure, reclining windshield, raked chassis, small grill, minimal ground clearance, slightly raked underside, and converging tail to keep the air flow attached.

These modifications will help enhance stability even at higher speeds as well as improve fuel efficiency.

 

About the Author

Carazoo.com is India’s first car portal that provides 360 exterior and interior car animations of New Cars India, Car Prices and Used Cars India, Second hand Car Sale for all car models available in India.

What are the strips attached to the bottom of a rear car bumper?

I've seen some cars with a strip hanging from the rear bumper just enough to touch the ground and it has a triangle attached to it. I've always wondered what it's for.

Anti-static strips. They ground out the car when you stop to pevent getting a shock when you get out.

Reid's wife, daughter injured in car crash
WASHINGTON, March 11 (UPI) -- Senate Majority Leader Harry Reid's wife and daughter were taken to a Washington-area hospital for treatment Thursday after a car crash, Reid's office said.

Thanks for visiting!

Tags: auto, car, car rear camera, car rear view camera, car rear view camera system, car rear view mirror, car rear window shade, rear, safety, video

This entry was posted on Wednesday, July 1st, 2009 at 12:48 am and is filed under Bluetooth Accessories. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.